Aocoda RC F405 V4 Flight Controller
3,999.00 ৳
Only 1 left in stock
Aocoda RC F405 V4 Flight Controller OSD Baro and BalckBox for Racing Drone
Specifications
- MCU: STM32F405RGT6, 168MHz, 1MB Flash
- Board V3.0-ICM Version: IMU: ICM42688 (SPI1)
- Board V3.0-MPU Version: IMU: MPU6888 (SPI1)
- Gyro: ICM42688P(SPI1)
- Baro: SPL06-001(I2C1)
- OSD: AT7456E(SPI2)
- Blackbox: 16MB(SPI3)
- Motor Output: 8ch
- 5x Uarts (1,2,3,4,5)
- 10x PWM outputs(including “LED strip” pad)
- 1x I2C
- 3x ADC (VBAT, RSSI, CURR)
- 3x LEDs for FC Status (Blue, Red) and 3V indicator(Red)
- Built-in inverter for SBUS input
- USB Type-C
- Dual camera input and free switching
- Receiver: ELRS/CRSF/S.BUS/Frsky/Futabayfysky/TBs Crossfre/DSMX
- DJI FPV OSD is supported by any spare Uart
Power
- Vbat Input: 12.6~33.6V (3~8S LiPo)
- BEC: 5V/2.5A, 9V/2.5A(Max.2.7A)
- No built-in Current Sensor
- Static power: 200mA@5V with Betaflight, 150mA@5V with ArduPilot
Physical
- Dimensions: 37mm*37mm
- Mounting Hole: M3 30.5mm*30.5mm
- Weight: 9.4g
FC Firmware
- BetaFlight: AOCODARCF405V3
- INAV: AOCODARCF405V3
- ArduPilot(ChiBiOS): AOCODARCF405V3
Including
- F405 V4 FC*1
- 8PIN SH1.0mm connection cable*1
- M3 *8 shock-absorbing ball *4
.jpg)
Related products
-
KK2.1.5 LCD Flight Control Board
4,499.00 ৳Add to cartKK2.1.5 LCD Flight Control Board (Red Switch) The kk 2.1.5 flight controller is next big evolution of the first generation KK flight controller boards. The KK2.1.5 was engineered from the ground up to bring multi-rotor flight to everyone, not just the experts. The LCD screen and built in software makes install and setup easier than …
-
DIATONE Mamba F405 Flight Controller
4,499.00 ৳Add to cartDIATONE Mamba F405 Flight Controller STM32 F405 MPU6000 OSD Built-in 5V 1.5A BEC 3-6S for RC FPV Racing Drone Quadcopter Specification: Item name: F405 Betaflight Flight Controller Input power: 10-28V (3-6S) BEC: 5V/1.5A MCU: STM32F405 Gyro: MPU6000 Flash: 16MB OSD: AT7456 Firmware: Fury F4 OSD Mounting hole: 30.5*30.5mm Weight: 6g Package Included: 1 x DIATONE …
-
SIM900A GSM /GPRS Module + Antenna
899.00 ৳Add to cartSIM900A GSM /GPRS Module + Antenna SIM900A Modem can work with any GSM network operator SIM card just like a mobile phone with its own unique phone number. The SIM900A GSM/GPRS modem is plug and play modem with RS232 serial communication supported. Hence Advantage of using this modem will be that its RS232 port can …
-
APM 2.8 Flight Controller Side Pin/Straight Pin
6,900.00 ৳ – 6,999.00 ৳Select optionsAPM 2.8 Multicopter Flight Controller APM is an open source flight control, can you play APM well depend on individual ability. Player must have ability of basic knowledge of electrical,mechanical, and also needs a certain degree of mental capacity, financialand material resources, energy support. If you’re not ready, then We recommend that you prepare some introductory information first. …
-
ArduPilot APM 2.8 Flight Controller Combo
9,399.00 ৳ – 10,499.00 ৳Select optionsArduPilot APM 2.8 Flight Controller Combo Introduction: Eliminate V2.52 Version Old 1.0mm 6P SM06B GPS interface , changed to the DF13-4P compass external I2C interface, Place the DF13-5P GPS interface with external interfaces of the compass , more convenient to connections GPS with external compass. Replaced the V2.52 I2C interface to multi-purpose MUX interfaces, which …
-
Ublox NEO-6m GPS Module
600.00 ৳Add to cartUblox NEO-6m GPS Module Ublox makes good gps. The Ublox NEO-6M gps engine on this board is a quite good one, with high precision binary output. It has also high sensitivity for indoor applications. The gps module have a battery for power backup and EEprom for storing configuration settings. The antenna is connected to module …
