Aocoda RC F405 V4 Flight Controller
3,999.00 ৳
In stock
Aocoda RC F405 V4 Flight Controller OSD Baro and BalckBox for Racing Drone
Specifications
- MCU: STM32F405RGT6, 168MHz, 1MB Flash
- Board V3.0-ICM Version: IMU: ICM42688 (SPI1)
- Board V3.0-MPU Version: IMU: MPU6888 (SPI1)
- Gyro: ICM42688P(SPI1)
- Baro: SPL06-001(I2C1)
- OSD: AT7456E(SPI2)
- Blackbox: 16MB(SPI3)
- Motor Output: 8ch
- 5x Uarts (1,2,3,4,5)
- 10x PWM outputs(including “LED strip” pad)
- 1x I2C
- 3x ADC (VBAT, RSSI, CURR)
- 3x LEDs for FC Status (Blue, Red) and 3V indicator(Red)
- Built-in inverter for SBUS input
- USB Type-C
- Dual camera input and free switching
- Receiver: ELRS/CRSF/S.BUS/Frsky/Futabayfysky/TBs Crossfre/DSMX
- DJI FPV OSD is supported by any spare Uart
Power
- Vbat Input: 12.6~33.6V (3~8S LiPo)
- BEC: 5V/2.5A, 9V/2.5A(Max.2.7A)
- No built-in Current Sensor
- Static power: 200mA@5V with Betaflight, 150mA@5V with ArduPilot
Physical
- Dimensions: 37mm*37mm
- Mounting Hole: M3 30.5mm*30.5mm
- Weight: 9.4g
FC Firmware
- BetaFlight: AOCODARCF405V3
- INAV: AOCODARCF405V3
- ArduPilot(ChiBiOS): AOCODARCF405V3
Including
- F405 V4 FC*1
- 8PIN SH1.0mm connection cable*1
- M3 *8 shock-absorbing ball *4
.jpg)
Related products
-
SpeedyBee F405 V4 BLS 55A Stack
9,200.00 ৳Read moreSpeedyBee F405 V4 BLS 55A Stack Elevate your drone’s performance with the SpeedyBee F405 V4 Stack, featuring STM32F405 MCU and ICM42688P gyro for precise control. The compact F405 V4 flight controller supports Bluetooth configuration and 6S LiPo power input, making it a versatile choice for FPV enthusiasts. Paired with the SpeedyBee BLS 55A 4-in-1 ESC, …
-
Ublox NEO-6m GPS Module
600.00 ৳Add to cartUblox NEO-6m GPS Module Ublox makes good gps. The Ublox NEO-6M gps engine on this board is a quite good one, with high precision binary output. It has also high sensitivity for indoor applications. The gps module have a battery for power backup and EEprom for storing configuration settings. The antenna is connected to module …
-
HC-06 bluetooth module
370.00 ৳Add to cartThis is a bluetooth module for use with any microcontroller. It uses the UART protocol to make it easy to send and receive data wirelessly. The HC-06 module is a slave only device. This means that it can connect to most phones and computers with bluetooth but it cannot connect to other slave only devices …
-
DJI Naza M Lite Flight Controller with GPS Combo
17,000.00 ৳Add to cartDJI Naza M Lite Flight Controller with GPS Combo for RC FPV Drone Quadcopter Original DJI Naza M Lite Multi Flyer Version Flight Control Controller w/ PMU Power Module & LED & Cables & GPS & stand holder All-In-One Design For entry-level enthusiasts, DJI now brings out the most cost-effective solution, the NAZA-M Lite flight …
-
KK2.1.5 LCD Flight Control Board
4,600.00 ৳Add to cartKK2.1.5 LCD Flight Control Board (Red Switch) The kk 2.1.5 flight controller is next big evolution of the first generation KK flight controller boards. The KK2.1.5 was engineered from the ground up to bring multi-rotor flight to everyone, not just the experts. The LCD screen and built in software makes install and setup easier than …
-
APM Pixhawk Power Module With XT60
599.00 ৳Add to cartAPM Pixhawk Power Module With XT60 and BEC Specifications: APM Pixhawk Power Module With XT60 is a simple way of providing your APM and pixhawk with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through a 6-pos cable. The on-board switching regulator outputs 5.3V and a maximum …
