BTS7960 43A H-bridge Motor Driver module
550.00 ৳
In stock
BTS7960 43A H-bridge Motor Driver module
This driver uses Infineon chips BTS7960 composed of high-power drive full H-bridge driver module with thermal over-current protection. Double BTS7960 H-bridge driver circuit, with a strong drive and braking, effectively isolating the microcontroller and motor driver! High-current 43A
Features:
Double BTS7960 large current (43 A) H bridge driver
5V isolate with MCU, and effectively protect MCU
5V power indicator on board
voltage indication of motor driver output end;
can solder heat sink
Just need four lines from MCU to driver module (GND. 5V. PWM1. PWM2)
isolation chip 5 V power supply (can share with MCU 5 V)
size: 4 * 5 * 1.2 cm
Able to reverse the motor forward, two PWM input frequency up to 25kHZ
two heat flow passing through an error signal output
isolated chip 5V power supply (can be shared with the MCU 5V), can also use the on-board 5V supply
the supply voltage 5.5V to 27V
Related products
-
New Rain 480A Brushed ESC With Cooling Fan
1,999.00 ৳Add to cartNew Rain 480A Brushed ESC With Cooling Fan Features: One-piece design ( built electrolytic capacitors ), fully waterproof and dustproof, adapt to climate and environment. Bidirectional operation mode, you can move forward and backward, for a variety of models. High-quality materials, with a strong resistance to current capacity. Powerful BEC output capability, over other competing …
-
Hobbywing Eagle Brushed ESC 20A/30A
1,250.00 ৳ – 1,350.00 ৳Select optionsHobbywing Eagle Brushed ESC 20A/30A Speed Controller For RC Model Specification: Brand Name: Hobbywing Item Name: Eagle 20A/30A Brushed ESC Output: Continuous 20/30A, Burst 30/40A up to 10 seconds Input Voltage: 2-3 cells lithium battery or 4-10 cells NiCd/NiMh battery BEC: 1A / 5V (Linear mode) PWM Frequency: 2 kHz Size: 45 x 21 x …
-
320A Brushed ESC for RC CAR/BOAT
1,100.00 ৳Add to cart320A Brushed ESC for RC CAR/BOAT Description HSP Henglong HPI 320A high voltage version with brush ESC remote control car two-way waterproof ESC supports 3S lithium battery 320A two-way high voltage version electronic governor with brake (with waterproof function) Battery support: NiMH, NiCd 4~6 groups (4.8V~7.2V); Lithium battery 3 groups (6V-12V) Current parameters: forward 320A, …
-
Dark Horse Model 480A Brushed ESC
1,699.00 ৳Add to cartDark Horse Model 480A Brushed ESC waterproof with T-Plug Description: Supports voltage range: 2-3s Lipo or 5-9 NiMH batteries. Protection voltage: 6v (factory can be set), when the voltage protection is effective, the throttle motor will be activated for 3 seconds to stop, and the throttle valve can be operated again for 3 seconds. Protection …
-
L293D Motor Driver Shield
220.00 ৳Add to cartDescription: L293D Motor Driver/Servo Shield for Arduino This Arduino compatible motor Driver shield is a full-featured products that it can be used to drive 4 DC motors or two 4-wire stepper and two 5V ”hobby” servo. It drive the DC motor and stepper with the L293D, and it drive the servo with Arduino”s pin9 and …
-
New Rain 320A Brushed Water Cooling ESC
2,000.00 ৳Read moreThis esc is dual mode design, can be set to forward & brake & reverse mode, or forward & reverse mode, very convenience to switch the mode. Input :2-3S Lipo or 6-9 NiMH battery BEC :5V 3A Continuous current :80A Transient current :320A Size: 42x28x24mm (L*W*H) Include: 1x Brushed ESC
