A3144 Hall Effect Sensor
15.00 ৳
In stock
A3144 Hall Effect Sensor
Features:
- 3.5V to 24V DC operation voltage
- Low current consumption
- Temperature compensation
- Wide operating voltage range
- Open-Collector pre-driver
- 50mA maximum sinking output current
- Reverse polarity protection
- Lead Free Package: TO-92
- Datasheet
Related products
-
L293D Motor Driver Shield
220.00 ৳Add to cartDescription: L293D Motor Driver/Servo Shield for Arduino This Arduino compatible motor Driver shield is a full-featured products that it can be used to drive 4 DC motors or two 4-wire stepper and two 5V ”hobby” servo. It drive the DC motor and stepper with the L293D, and it drive the servo with Arduino”s pin9 and …
-
Add to cart
Flame Sensor fire detection module Flame Detection Sensor Module is sensitive to the flame, but also can detect ordinary light. Usually used as a flame alarm. Detects a flame or a light source of a wavelength in the range of 760nm-1100 nm. Detection point of about 60 degrees, particularly sensitive to the flame spectrum. This …
-
Add to cart
XL6009 Step Up Power Module DC-DC Boost Converter With Display Feature: Length: 60mm Width: 35mm Height: 13.5mm Weight: 24g Input Voltage: 3-32V Output Voltage: 5-35V Output Current: 4A(MAX) Output Ripple: 50mV (Higher voltage, larger current and ripple) Switching Frequency: 400KHz (LM2577 only 50KHz) Operating Temperature: -45 to +85 degree centigrade Transfer Efficiency: less than or …
XL6009 Step Up Power Module DC-DC Boost Converter With DisplayRead More
-
Add to cart
LM2596 DC-DC Buck Step Down Converter Module with LCD voltmeter Features: 1. Input voltage range: 4-40 v (40 v to limit the highest voltage). 2. Output voltage range:1.25V – 37V (decompression mode, input output must be greater than 2 V above). 3. Output current: 2 A continuous output. 4. Output power: the maximum 15 w. …
LM2596 DC-DC Buck Step Down Converter Module with LCD voltmeterRead More
-
Add to cart
ESP32-CAM WiFi + Bluetooth Camera Module Description: 1. ESP32-CAM is a WIFI+ bluetooth dual-mode development board that uses PCB on-board antennas and cores based on ESP32 chips. It can work independently as a minimum system. 2. ESP integrates WiFi, traditional bluetooth and BLE Beacon, with 2 high-performance 32-bit LX6 CPUs, 7-stage pipeline architecture, main frequency …
-
Flex Sensor 2.2″
1,400.00 ৳Add to cartFlex Sensor 2.2″ Inch Bend Flex Sensor For Robotic Hand Electronic Gloves Flex2.2 Flex Sensor Pressure Sensor Resistive Flex Sensor Robotic Arm Power Glove Measuring Bending DIY A flex sensor or bend sensor is a sensor that measures the amount of deflection or bending. Usually, the sensor is stuck to the surface, and the resistance of the sensor element is varied by bending the …
