A3144 Hall Effect Sensor
15.00 ৳
In stock
A3144 Hall Effect Sensor
Features:
- 3.5V to 24V DC operation voltage
- Low current consumption
- Temperature compensation
- Wide operating voltage range
- Open-Collector pre-driver
- 50mA maximum sinking output current
- Reverse polarity protection
- Lead Free Package: TO-92
- Datasheet
Related products
-
Add to cart
W1209 Digital Temperature Controller Switch Module Description: W1209 DC 12V Red LED Digital Heat Cool Thermostat Temperature Control Thermometer Thermo Controller Switch Module + NTC Sensor Specifications: Temperature range :-50-110 ° Dimensions: 48.5 * 40mm Temperature control mode: ON / OFF Resolution:When temperature is 0.1°, the resolution is -9.9~99.9, other temperature segment is 1° Control …
-
PIR Motion Sensor
99.00 ৳Add to cartPIR Motion Sensor PIR Motion Detector Module Features Settling time: 60 seconds Compact size (24 x 32 mm) Supply Voltage: DC3V-5V Current drain :< 50uA Voltage Output: High/Low level signal: 0-3.3V High sensitivity Delay time: 5s-18 minute(as customer requirement) Operation Temperature: -15oC -70 oC Infrared sensor: dual-element, low noise, high sensitivity Light sensor: CdS photocell …
-
2.4GHz Wireless Module NRF24L01
130.00 ৳ – 330.00 ৳Select options2.4GHz Wireless Module NRF24L01 with antenna or without external antenna Description: The real GFSK monolithic transceiver chip Built-in hardware and link layer Automatic response and automatic retransmission function Address and CRC check function Channel switching time is very short, can be used for frequency hopping Fully compatible with nRF24XX series The global open ISM frequency …
-
Add to cart
Flame Sensor fire detection module Flame Detection Sensor Module is sensitive to the flame, but also can detect ordinary light. Usually used as a flame alarm. Detects a flame or a light source of a wavelength in the range of 760nm-1100 nm. Detection point of about 60 degrees, particularly sensitive to the flame spectrum. This …
-
LDR Sensor Module
55.00 ৳Add to cartLDR Sensor Module Features: Can detect ambient brightness and light intensity Adjustable sensitivity (via blue digital potentiometer adjustment) Operating voltage 3.3V-5V Easy to use with Arduino Output Type: Analog voltage output -A0 Digital switching outputs (0 and 1) -D0 With fixed bolt hole for easy installation Small board PCB size: 3cm * 1.6cm Power indicator …
-
HC-06 bluetooth module
370.00 ৳Add to cartThis is a bluetooth module for use with any microcontroller. It uses the UART protocol to make it easy to send and receive data wirelessly. The HC-06 module is a slave only device. This means that it can connect to most phones and computers with bluetooth but it cannot connect to other slave only devices …
