A3144 Hall Effect Sensor
15.00 ৳
In stock
A3144 Hall Effect Sensor
Features:
- 3.5V to 24V DC operation voltage
- Low current consumption
- Temperature compensation
- Wide operating voltage range
- Open-Collector pre-driver
- 50mA maximum sinking output current
- Reverse polarity protection
- Lead Free Package: TO-92
- Datasheet
Related products
-
HC-06 bluetooth module
370.00 ৳Add to cartThis is a bluetooth module for use with any microcontroller. It uses the UART protocol to make it easy to send and receive data wirelessly. The HC-06 module is a slave only device. This means that it can connect to most phones and computers with bluetooth but it cannot connect to other slave only devices …
-
Add to cartThis precision sensor is the best low-cost sensing solution for measuring barometric pressure and temperature. Because pressure changes with altitude you can also use it as an altimeter! The sensor is soldered onto a PCB with a 3.3V regulator, I2C level shifter and pull-up resistors on the I2C pins. Specifications: Size: 21mm x 18mm 1.8V …
-
Flex Sensor 2.2″
1,400.00 ৳Add to cartFlex Sensor 2.2″ Inch Bend Flex Sensor For Robotic Hand Electronic Gloves Flex2.2 Flex Sensor Pressure Sensor Resistive Flex Sensor Robotic Arm Power Glove Measuring Bending DIY A flex sensor or bend sensor is a sensor that measures the amount of deflection or bending. Usually, the sensor is stuck to the surface, and the resistance of the sensor element is varied by bending the …
-
PIR Motion Sensor
99.00 ৳Add to cartPIR Motion Sensor PIR Motion Detector Module Features Settling time: 60 seconds Compact size (24 x 32 mm) Supply Voltage: DC3V-5V Current drain :< 50uA Voltage Output: High/Low level signal: 0-3.3V High sensitivity Delay time: 5s-18 minute(as customer requirement) Operation Temperature: -15oC -70 oC Infrared sensor: dual-element, low noise, high sensitivity Light sensor: CdS photocell …
-
L293D Motor Driver Shield
220.00 ৳Add to cartDescription: L293D Motor Driver/Servo Shield for Arduino This Arduino compatible motor Driver shield is a full-featured products that it can be used to drive 4 DC motors or two 4-wire stepper and two 5V ”hobby” servo. It drive the DC motor and stepper with the L293D, and it drive the servo with Arduino”s pin9 and …
-
Add to cart
HW-586 Li-ion Lithium Lead-acid Battery Capacity Tester Resistance Discharge Meter Description: Material: Electrical components HW-586 battery capacity tester discharge type 1.2-12V external load capacity of the battery and other tests 18650 Tools, single-function, by controlling the load off and get real-time integrated discharge current capacity results Maximum support 15V 3A discharged through the discharge voltage …
HW-586 Li-ion Lithium Lead-acid Battery Capacity TesterRead More
